FL: 407-248-1142  RI: 401-438-1500  CA: 213-612-0622 - E-STORE IS CURRENTLY UNDER MAINTENANCE! CALL FL FOR SPARE PART ORDERS!                                                                                                                                                                                                                    

LaserStar

Dental Lab Laser Welding: Repairing a Clasp

Repairing a Broken Clasp - Partial Dentures

Note: Most partial dentures are Cobalt/Chrome Co/Cr or Nickel/Chrome NC/CR alloy. The laser’s energy excites the carbon in the weld zone and can make the alloy brittle. For this reason, we will weld these alloys and add filler wire at the same time. LaserStar welding wire is a carbon-free alloy. When these high carbon alloys are welded with the carbon-free welding wire, a new low-carbon alloy is born thus resulting in a strong weld.

Prepping the Clasp:

If the clasp broke off cleanly, the clasp will fit against the partial like a puzzle. If the clasp does not fit properly, grind each side of the break so the clasp fits flush together.

Placement of the Clasp:

Set the partial in the model and align the break of the clasp. Hold the clasp in place with your fingers. A small amount of putty or wax can be used to hold the clasp against the model.

Setting the Laser Welder and Tacking the Clasp in Place

Set the LaserStar laser welder on the CLASP REPAIR setting. The setting may need to be adjusted based on the gauge. Tack the clasp into place, usually only one laser pulse is needed to hold the clasp in place.

Running a Bead:

At this time, the partial denture can be removed from the model. Holding the appropriate LaserStar filler in place, run a welding bead around the clasp.

Hammering and Smoothing:

It is now necessary to increase the Beam Diameter (Ø); this will reduce the depth of the weld resulting in a “Surface weld.” Also increase the Hertz (Hz); this will enable the laser welder to fire more rapidly keeping the metal molten for ease of smoothing. Fire the laser welder moving the item slightly in a back and forth motion. This will “Feather” the metal across the fill zone resulting in a smooth hammering effect.

Note: Keep all hammering and smoothing to a minimum, too many laser pulses in a small area can heat the alloy causing annealing, burning or damage to nearby acrylic.

Adjusting the Clasp

The clasp can now be adjusted with a pair of pliers to fit the model.
 


Clean Up
Clean up the area by grinding, filing or using a rubber wheel. Then clean accordingly.

Examples of Clasp Repair using the LaserStar are shown above.

 

"I do not think we could do without our laser welder!  All of our departments use it daily.  We feel it has paid for itself many times over.”

Rob Allen, Lab Manager
Stern Empire Dental
(National Dentex Group)
Houston, TX

Florida (Headquarters, Manufacturing, Sales & Training)
2461 Orlando Central Parkway, Orlando, FL 32809 USA
California (Sales & Training Center)
20 East Foothill Boulevard, Suite 128, Arcadia, CA 91006 USA
Rhode Island (Sales & Training Center)
100 Jefferson Boulevard, Suite 315, Warwick, RI 02888 USA

Made in USA
© 2024 LaserStar Technologies Corporation. All rights reserved.