FL: 407-248-1142  RI: 401-438-1500  CA: 213-612-0622 - E-STORE IS CURRENTLY UNDER MAINTENANCE! CALL FL FOR SPARE PART ORDERS!                                                                                                                                                                                                                    

LaserStar

Jewelry Laser Welding: Filling Porosity

Tips for Filling Porosity with a Laser Welder

Porosity on Surface

Porosity when viewed from the surface, may appear to be a hole or pin-hole. Below is an example of deep porosity viewed from the surface of a ring shank.

Cross Section of Subsurface Porosity

Deep porosity may actually be an open pocket under the surface of the metal and may also contain impurities. Below is an example of a cross section of deep porosity.

Clean Out the Hole and Probe for Additional Porosity

Set the LaserStar for the porosity setting in the alloy you wish to fill. Fire the LaserStar at a 90° angle into the porosity hole. Larger holes may need several shots. This process will burn out any remaining investment or impurities trapped within the porosity hole and will also expose any other subsurface porosity. This step will also reshape the hole for easier filling.

 

Filling Porosity with the LaserStar - Jewelry Repair

Filling Porosity with the LaserStar - Jewelry Repair

Filling

Hold the LaserStar filler wire of the same alloy at a 30° angle or less making sure the tip of the filler wire touches the base metal. Fire the LaserStar at a 90° angle to the hole.

This will “puddle” the filler wire into the porosity hole filling the hole from the bottom up.

Make sure the hole is completely filled to slightly above the base metal. This ensures that the gauge of the base metal is not compromised during final finishing.

Filling Porosity with the LaserStar - Jewelry Repair

Filling Porosity with the LaserStar - Jewelry Repair

Filling Porosity with the LaserStar - Jewelry Repair

Hammering and Smoothing

It is now necessary to increase the Beam Diameter (Ø); this will reduce the depth of the weld resulting in a “Surface Weld.” Also, increase the Hertz (Hz), this will enable the LaserStar to fire more rapidly keeping the metal molten for ease of smoothing. Fire the LaserStar moving the item slightly in a back and forth motion. This will “feather” the metal across the fill zone resulting in a smooth hammering effect.

Clean up

Clean up the area by filing, sanding or using a rubber wheel. Then polish and clean accordingly. Sample of finished ring shown below.

Filling Porosity with the LaserStar - Jewelry Repair

Filling Porosity Using the LaserStar - Jewelry Repair


Florida (Headquarters, Manufacturing, Sales & Training)
2461 Orlando Central Parkway, Orlando, FL 32809 USA
California (Sales & Training Center)
20 East Foothill Boulevard, Suite 128, Arcadia, CA 91006 USA
Rhode Island (Sales & Training Center)
100 Jefferson Boulevard, Suite 315, Warwick, RI 02888 USA

Made in USA
© 2024 LaserStar Technologies Corporation. All rights reserved.